config plate_thickness pt ThermoFlex Used to add additional thickness values to the Thermoflex. Can be used to override programmed default values. LIST THICKNESS can be used to show current settings as well as the scaling correction values associated with each thickness. The NVS column from the LIST THICKNESS command will show the values placed in this NVS parameter. If the value is non-zero, it will become the value used (confirmed by looking at the ACTIVE columm) and the scaling correction value for the current media is associated with this "active" value. uint16

0

0-6350

14 This is necessary so that a new thickness can be utilized without having to modify the internal hardcoded settings and rebuilding a new version. Thickness values in this table are used to match up measured plate thicknesses and look up a scaling correction factor for the thickness. cfg

../commands/list_thickness.xmlCommand: list thickness

../nvs/media_cfg_sc.xmlNVS: media sc

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:36:43 2008 PST